Rubber Parts, Miscellaneous


 

Rubber boot which covers the wiring on the back of the U.S. market taillight number 07011271

CABLE RUBBER COVER SET-LD2

US$112.68 US$107.04

Gray rubber cover set for the cables and wiring on the handlebars of LD Mk2 models. Includes all rubber tubing and molded fittings patterned exactly after the original items. Shown in Innocenti parts books as 12771026 for the left side set and 12771036 for the right side set. Not sold separately.

RUBBER WASHERS, PK/10

US$9.66 US$9.18

Reinforced rubber washers for use between frame and footboards, bridge piece, etc. (pk. of 10)

These ivory colored rubber protectors for the lower coil spring mounting bolts on the front seats of LD models will keep your side panels from being scratched when you remove them. Priced each.

Rubber boot which covers the wiring terminal on the engine for the TV175 Series 1 model

Black rubber triangular grommet which holds the throttle cable and spark plug wire to the frame on Li/SX/TV/GP/DL/Serveta models

Black rubber air intake boot for Series 1 frame breather models

Rubber boot which covers the spring on the side panel latch assembly of Series 1/2 Li & TV and all LD models. Priced each.

Black rubber buffer that installs in two holes in the rear fender and butts up against the inside of the frame on all Series 1 and 2 models.

FUEL CAP GASKET

US$2.22 US$2.11

Black rubber seal on the underside of the gas cap on all Li/SX/TV/GP/DL/J/Serveta models

ENGINE BUMP STOP-LI

US$4.86 US$4.62

Rubber bump stop which presses into engine case and limits suspension travel on all Series 1/2/3 models (expect TV175 Series 1; see part #15010060)

AIR FILTER GASKET

US$2.70 US$2.57

Oval shaped foam rubber gasket for the air intake neck on late Series 1 and early Series 2 models.

Round black rubber gasket at the top of the air box on late Series 2 air boxes with small diameter neck.

Rubber boot which covers the rear end of the shift linkage tie bar on all Series 1/2/3 models (except TV175 Series 1).

Small white or gray rubber buffer between license plate holder and frame on Series 1 and 2 machines. Two required.

Large white or gray rubber buffer between license plate holder and frame on Series 1 and 2 machines. One required.

Black rubber seal at the top of the air box neck on all Series 3 models (and some early Series 2 models; replaces part #19016033)

Rubber anti-vibration buffers which fit in the large holes in between the mounting holes of the fan shroud on most Series 1/2/3 models. Priced each.

 

Rubber boot which covers the wiring on the back of the U.S. market taillight number 07011271

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
0 Item(s)
US$0.00